Dear visitor,
VoIPLine Telecom uses latest technologies in web development. Unfortunately your web browser is not supported and some parts of our we site may not be displayed correctly. Below are links to the latest versions of Google Chrome, Mozilla Firefox and MS Edge browser.

Knowledge base centre

PBX SIP Device Yealink Configuration

yealink_device_setup_1.gif


In this tutorial we will configure a Yealink handset, to a SIP device assigned to a user inside PBX. 

Yealink devices are used as an example, as they are the most widely used handset on our network. However, PBX supports any softphone or handset that support the SIP protocol.

Additionally, the Yealink devices are extremely reliable and tested internally by our engineering team with PBX, this is another reason why we heavily recommend these units. 

Should you not be using Yealink handsets, apply techniques shown in the article to configure your manufacturer of IP handset. Or alternatively contact our support department for assistance.  

Follow the instructions, supplied in the device user manual to assemble the handset. The diagram below will also supply a visual representation of where the cables will need to be plugged in, using a Yealink device. 

Connect the internet port to an Ethernet cable plugged into your internal network, the power supply and the PC port to an Ethernet port attached to your computer, if required. 

 

Once plugged in find your phone’s IP address, press the OK button on the Yealink device. Locate the address listed in the IPv4 section. 

Type the IPv4 address into your web browser to access the web-interface. Making sure that your PC is on the same network range as your handset. 



Locate the login details of you handset and enter them into the login page, if the handset has been purchased via us then the details would have been emailed during the order process. 

Click on the accounts tab inside the Yealink portal. 

Login to your PBX customer portal, click on the SIP devices tab and locate the device you want to configure. 

SIPdevice.PNG

Next, fill in the details in the Yealink web portal from your SIP device information you have as below. 

Label: Set the label field to the name you want to appear on the screen of your handset. 

Display name: Set the display name field to the name to the same as the label.

Register name: Enter the SIP login from PBX, into the register name. 

Username: Enter the SIP login from PBX, into the username field. 

Password: Enter the SIP password from PBX, into the password field. 

Transport: Set to transport protocol to UDP.

Server Host: Enter the SIP server address and port number from PBX, into the server host field.   

Server Expires: Set the refresh rate to 120 from the default 3600. 

NAT: Select STUN from the drop down list. 

Check all the fields carefully, confirm that they match the details in your SIP devices section of PBX and make sure that you have applied the configuration inside PBX before trying to register a new device. 

Change the line active field from disabled to enabled, and click confirm. The registered status should appear if the details have been entered correctly. 

yealinkconfig.PNG

Locate settings tab then time and date. Ensure DHCP time is disabled, click on the timezone drop down menu and select the relevant time zone. 

Click on the settings tab and then SIP, change the local SIP port to a digit above 6000 making sure that each device has a different local SIP port. 

Finally, navigate to the features menu and general, disable the allow IP call drop down menu and confirm the changes. 

You should now be able to make and receive calls via your device. Should any further help be require please contact our support department.

See Also

PBX Automatic Device Provisioning

A quick search will help you find answers, to most of the FAQ's.
If you are unable to a find solution from the knowledge base centre, please contact
your service provider for technical assistance.